Showing posts with label staining wood. Show all posts
Showing posts with label staining wood. Show all posts

Friday, December 30, 2011

Easy and Affordable DIY Table Transformation

Some of you may remember this table I shared a while back here that I found at my local DI for $15. Although it was missing it's leaf, it was in otherwise great condition for a refurb and all solid wood.


Using the same methods I shared with you HERE and HERE for sanding off the previous stain and finishes, I stripped the wood down bare on top and then wiped on several coats of Minwax Wood Finish Stain in Dark Walnut. 
After the stain had dried, I applied a few coats of Annie Sloan Soft Dark Wax.



I've had a few readers ask how to apply this stain on pieces like this where the grain meets together in the center without creating streaky lines.  Truthfully, I just use a rag and word with the grain in quarter sections at a time trying to "stay inside the lines" like I did with my first dining room table.

It takes a bit of practice and doesn't always look perfect but it looks good enough for me!  I haven't had much success in working against the grain or in perfectly straight lines that don't follow the wood.  If you've found it to work better for you another way, do share!

I've also found that even when I try to sand the tabletop down as evenly as possible, and pre-treat it with wood conditioner to prevent uneven color, sometimes the wood just takes differently.  That happened in this case and while I was so frustrated at first I eventually decided to just go with it and am so happy with the end result.  It gave it a more rustic and natural un-factory like finish.




Also, I have found that in nearly every piece I've stained that the lip below the main surface top always stains much much darker than the top.  Usually, the lip is made of MDF or similar so it absorbs the stain differently than the solid wood like maple, oak or alder does.  It doesn't bother me that it appears darker, but if it's not your thing then you may want to consider choosing a few shades lighter for the lip, or opt to paint the whole top instead of stain it.

Then, the easiest part was slabbing on a few coats of cream colored Behr Paint and Primer in One that I have on hand from one of my oops paint $5/gallon purchases.  After that dried, I glazed the nooks and crannies with a combo of Valspar's Antiquing Glaze and my Ralph Lauren Faux techniquing glaze in a cocoa color.  Lastly, I finished the apron and legs off with a few coats of poly spray for protection.  You know how I love the contrast of a dark wooden top with creamy white legs.  Sexaaaaay.

Then, I quickly beautified these cute little chairs that I recently bought from my friend's younger bro for super cheap.  Haven't all of you had a set like these in your house growing up at one point?  I know I sure did. 

Since the wood matched pretty closely to the tabletop I had just stained, I opted to keep a part of the chair in it's original finish.  I taped up the back dowels and spray painted the rest of the chair with Krylon Dual's Paint and Primer in One in cream.  (I started to paint one chair with a roller and brush using the same Behr paint I used for the table but with all the little spindles and legs, it was taking FOREVER so spray paint became my new best friend for the day).  After a few hits of sandpaper to the high points and some of my glaze concoction to the nooks and crannies, the chairs turned out like this:



Not quite like the ones you grew up with anymore, right?

So, here is how this cute little dining family of a table and 4 chairs looks together.




You don't have to have a lot of money or even a lot of talent to make a great looking dining room set.  This whole set cost me a whopping $35.  Yes, $35!  You can do it too peeps! 

I'm sharing this makeover with my friends here:  Go check them out for more inspiration!
The DIY Show Off




Photobucket



Domestically Speaking

UndertheTableandDreaming



Transformation Thursday

Furniture Feature Fridays







XO

~PW

Wednesday, May 18, 2011

Frenchy Dresser Reveal

Hello, friends! 

I have been super busy working on the yard this week, but have no excuse not to post today since it is raining yet again... this blasted Utah weather! 

I am thrilled to share with you the final reveal of the french dresser I completed for my darling Sister in law, Willow.  I have to tell you, this project gave me a run for my money with several challenges I ran into.  I am so happy to be able to finally show a beautiful finished product.

As a reminder, or for those who are stopping by for the first time today, here is the before:



Unlike many of my furniture transformations, this one was already a cute "before".  It just wasn't the color my sister was going for, and the glaze job wasn't her style.  She felt it looked dirty.  Here, ladies and gentlemen (if any) is the after:

 As with many of my transformations, the top was stripped and re stained a deep color to match some of her existing Ethan Allen Wood furniture.  (this was the process that about killed me but through trial and error we ended with a beautiful finished product).  I will share the process after the pics.

Gorgeous stained wood top that shows several imperfections, adding to its charm and character

 I ever so lightly distressed the corners and high points to bring out some of the white hiding underneath and in places some of the natural wood.
  Full angle of the gorgeous stained wood top
 Crystal knobs purchased at Anthropologie (hey, some things are worth a splurge...)
My sister in law found these perfect antiqued pewter pulls HERE.  They absolutely make the piece (though they were a pain in my rear end to install)  You know I love you, Willow!  :)
 

I am thrilled with the way this piece turned out and can't wait to see it in Willow's master bedroom once her makeover is complete. 

Here's how I transformed this piece.
  •  I lightly sanded down the dresser and drawers to get rid of all of the pieces of sawdust/ dirt that had been painted over.
  
  • I stripped the poly, glaze and paint from the top slab of wood. I have found that stripper works best if you first sand your piece to get rid of the top protective coat.  Once I sanded it down, I applied a VERY THICK layer of Citristrip with a paint brush in the direction of the grain.


  • After 12 hours of letting the stripper sit (I have found this to be the magic amount of time with this product), I scraped the layers of paint off with a stripping tool.  If the paint hasn't become tacky, it's not ready yet.  If it's been 12 hours and still isn't tacky, I have found that it needs more product.  Slab on another coat of stripper, wait 12 more hours and then try again.  It should not be labor intensive and should just pull right up.  Trust me on this one.  I spent about 5 hours stripping one leaf of my dining room table before I learned the trick. You can thank me later :)

  • Once I had scraped off as much paint as I could get, I scrubbed the entire surface with mineral spirits, using an old scrub brush to clean off any residual stripper.

  • Then, I took this baby outside and sanded off the rest of the paint residue with a coarse sand paper on my corner cat sander, followed by a very fine sand paper using an orbital sander to avoid the squiggly lines that can come from other sanders (per my fabulous reader's suggestions from another project).


I took very special care with the sander around the hand carved edges, which I discovered was cut out of a much softer wood, probably pine.

Once finished, I had uncovered this gorgeous wood.

  • I used a toothbrush with mineral spirits again to try and scrub as much paint as I could out of the dings that were on top and too deep to sand off.
  • Next, I applied wood conditioner using a clean cloth (leftover drop cloth from this chair) and followed it with a coat of minwax stain in Dark Walnut.



As you can see, it looked TERRIBLE! I wanted to cry.  Seriously.  I should have known it wouldn't have turned out well with the way all of these white little streaks popped up after the conditioner, but I thought the depth of the color would hide that. Also, you can see that there are tons of discolorations across the top.  The pine trim section soaked up that stain so strongly that it looked almost black after one coat. 

After throwing a few tantrums and seriously considering rolling paint right over the top of all that hard work, I emailed a few talented gals.  Sweet Marian, or Miss Mustard Seed herself responded to my plea for suggestions with a great idea to try and slather on a ton of stain, let it soak for a while, and see if it changed anything.  After all, nothing could hurt at this point.  I am so grateful to her for taking the time to reply to me and for offering such great insight.
  •  I went ahead and did just that.  I ran to Home Depot and picked up another can of stain in Gunstock.  My hope was that something with a lot of red/ orange undertones would help those white streaks to appear more golden, rather than such a stark contrast against the dark walnut.  I would have never chosen this color on its own, but on top of the dark walnut, it worked miracles!



The discolorations were still evident, and it certainly didn't look like a perfect piece, but it was perfect enough for me!  Gunstock in a huge amount did the trick. :)
  • Lastly for the top, I applied several coats of Minwax Polycrylic protective finish in Semi-gloss in hopes that adding a sheen would help to disguise the discolorations.  Normally, I prefer to finish wood stained tops with wax, but this was a unique situation. I sanded down lightly after each coat of poly with steel wool to get rid of any brush/ roller lines.



Alas, the top was finished!

The drawers and dresser were like a walk in the park compared to this blasted lovely top.

  • I painted everything in "Seadrifter" by Kwal Howell, color matched by Behr with their Paint and Primer in One in a satin finish. 


  • I lightly distressed the drawers and dresser, focusing on the corners and high points.  Then, I rubbed on a coat of Minwax Paste Finishing Wax with some clean drop cloth, and installed the new hardware. 

And there you have it,  the 1000 step process of how I achieved this look!  Fortunately, I have a beautiful finished piece to be proud of. 



 The moral of this story is, don't give up!  I can't tell you how many projects of mine I have wanted to just roll white paint over everything and start over.  Sometimes, you just need to keep trucking along and it really will all pull together in the end! 

Thanks for listening to my cheesy pep talk... it's really just a reminder to myself.

Pictures of the dresser in Willow's fabulous bedroom will be coming soon!  Stay Tuned....


XoXo

~PW

I'm sharing this transformation with these awesome parties.  Check them out!



Tip Junkie handmade projects

The DIY Show Off




My Uncommon Slice of Suburbia

Photobucket







Domestically Speaking








Funky Junk's Saturday Nite Special


UndertheTableandDreaming



















Transformation Thursday

Furniture Feature Fridays